中文简体The simplest way to make a hole in tempered glass involves the use of special tools and materials, as well as the correct operating steps.
The following are the basic steps for making a hole in tempered glass:
Prepare tools and materials: You need to prepare an electric drill, a special barrel, an appropriate amount of water, a glass drill bit, etc.
Determine the location and size of the hole: Use a ruler and a marker to mark the location of the hole on the tempered glass to ensure that the location is accurate.
Drilling: Use a glass drill bit to drill holes at the marked location with an electric drill. Keep the glass moist during operation to prevent glass fragments from splashing and injuring people.
Cleaning and inspection: After drilling the hole, rinse the debris on the glass with clean water, and check whether the hole meets the requirements and whether there are defects such as cracks.
Precautions:
Before performing the drilling operation, make sure that the thickness of the tempered glass reaches more than 12 mm. It is not suitable to drill holes in tempered glass that is too thin or of poor quality.
Keep steady and apply force evenly during operation to avoid glass breakage.
Wear appropriate protective equipment such as gloves and goggles during operation to prevent injuries caused by broken glass.
Please follow the above steps carefully, or drill holes in tempered glass under the guidance of professionals to ensure safety and the quality of the holes.
